Engine Spark Knock – Explaining – That Annoying Sound of Tapping

Engine spark strike occurs when the fuel mixture is subjected to too much compression heat. So if your engine is making that annoying tapping, pinging, or rattling sound, you are probably experiencing spark bumps in the machine.

Consequently, whenever the pressures of the combustion chamber become high enough, abnormal combustion may occur. Eventually, this could lead to a burnt cylinder head gasket, broken rings, cracked piston earth, and flatten the connecting rod bearings.

The Other Causes of Engine Spark

  • Defective valve (EGR)
  • Detonation sensor failure
  • Excessive accumulation of carbon
  • Vacuum leaks
  • Greater than normal compression
  • Exhaust backpressure
  • Poor fuel
  • Excessive engine temperatures

Faulty EGR valve in Engine Spark

The valve (EGR) must be opened when the engine is accelerating or dragging a load. The valve (EGR) must be opened. This allows the intake vacuum to suck part of the exhaust through the valve (EGR); to slightly dilute the air/fuel mixture. In addition, this reduces combustion temperatures and prevents detonation. Review the actions of the EGR valve and look for the accumulation of carbon deposits. Try cleaning the coal deposits or replace the valve (EGR) if it is defective.

Detonation Sensor Detects Engine Spark Detonation

Its engine has a detonation sensor that detects this noise and tells the computer to delay the power-on time. Engine spark strike can occur when. The machine is working hard under load, which causes the (PCM) to slow synchronization. This reduces the power a bit but protects your engine from damage. However, if the detonation sensor does not work. The synchronization of the spark will not be delayed when it should. Consequently, you may hear a metallic noise or rattle when; accelerating, driving uphill, or dragging the engine.

Excessive Accumulation of Carbon

  • Older high-mileage engines
  • Vehicles that never fully heat up
  • Only short distances are driven

Treating your engine with a carbon cleaner or fuel system additive usually clarifies this.

More significant than average compression of Engine Spark

One of the causes could be an engine with boring cylinders oversized. This can increase the static compression ratio of the machine. Another could be a butt that has been repaired to restore flatness. This will reduce the volume of the burning chamber and increase the engine’s static compression ratio.

These changes will increase the power of the engine but; also the risk of engine spark strike in regular 87-octane fuel. Supercharged or turbocharged engines are also at much greater risk. This is because the forced air training system increases compression.

Exhaust Back Pressure

High backpressure is a typical exhaust system problem. This can happen due to a clogged exhaust pipe, catalytic converter or silencer. So, a clogged converter is the most common cause of exhaust backpressure buildup. It will restrict the engine’s airflow, causing the engine to run hotter and lose power, leading to pinging or hitting. In addition. A catalytic converter will often become clogged due to overheating of old age or fuel contamination.

Uses of Poor fuel

Regular-grade gasoline should have an octane rating of 87, but that’s not always the case. The solution for this is to test a mid-range or premium gas tank. The premium costs more but may be needed to reduce shocks. Or, if you continually buy gas at a similar gas place, try a different gas station. Don’t buy the cheapest gasoline you can find.

The Advantages of Engine Spark

The advantages of economizing a 4-stroke spark-ignition (SI) engine shoot from shifting the operating points used in the machine map for any flywheel torque. The regulation is wider-open to the advantage of reduced pumping losses. At the same time, the mechanical efficacy increases. These savings can help offset the additive technologies required to recover the power output. Some means of increasing actual work has to be if to retain installed power in a vehicle.

This does by pressure charging the engine, with turbocharging is generally favourite because it allows some exhaust gas energy recapture. There are significant synergies with other ordinary technologies such as direct injection  and camshaft phasing devices,

engine spark

Spark Ignition Engine Fundamentals

The spark-ignition engine exploits the Otto cycle for a four-stroke engine. The bike has been These comprise an intake stroke when a fuel-air mixture into the machine. A compression stroke when the mixture compress. A power stroke mixture ignites, and stages or strokes of the cycle are shown again in Fig. 4.1.

There are some common use technical terms associated with this cycle. The engine’s stroke is the distance the piston moves from the top of the cylinder to the bottom of the cylinder. Twice coldness among the centre of the crankshaft and the centre of the bearing attaching the involving pole to the crankshaft. Once the piston is at the highest of its stroke name the top dead centre and the place bottom of the stroke call the bottom dead centre. Force advance in the piston during the power stroke apply towards the shaft arm as a turning minute. There is no turning second around the crankshaft at TDC and BDC.

On the other hand, the turning moment will be the most excellent midway between TDC and BDC. Therefore, the volume in the cylinder is at its smallest when the piston is at TDC. It is at its extreme when the piston is at BDC. The engine shift generally referred to as the size of the engine, is the difference in volume between TDC and BDC. For a multi-cylinder engine, the importance of all the cylinders adds together to give the total engine size.


Finally, the engine sparks strike occurs when; excessive heat and pressure cause the air/fuel mixture to ignite automatically. This produces multiple flame fronts, within the burning chamber, rather than a single flame front. When these various flames collide, they do it with an explosive force that produces a sudden increase in the pressure of the cylinder. In addition, along with this, there is a high-pitched metallic beep or a knocking noise from the engine.

Also Read:  What is Interface? -Definition, Function, Example, And More